Na tej stronie dowiesz się:

Returning short distance to the screen (TRIP/PARTIAL)

A short press of the F button restores the short distance value (TRIP/PARTIAL).

Attention. If a short distance is already shown on the display, it will be deleted.

Hint. If you are not sure, press arrow to go to ODO and then F again to return to TRIP

Deleting short distance (TRIP/PARTIAL)

Briefly press the F button while in the screen where the TRIP short distance is displayed.

From any measurement function, press the arrow to go to the long distance screen.

Hint. Once you are in this screen, pressing the arrow will correct your distance.

If you are in the long distance screen, press the arrow to correct the distance.

Hint. If you are not in the long distance screen, press the arrow twice to correct the distance.

press and hold the F button until the display starts flashing.
then press the F button briefly to browse through the functions:
- long distance
- tension
- speed
- course
- time
- short way
Once you have set the function you want to display on the screen, stop pressing the F button at the appropriate moment

recall the long distance by pressing the arrow
press two arrows at the same time to call up the editing screen – one horizontal line will appear on the display next to the road indication
- use the arrows to increase/decrease the digit value
- use the F button to move the edit field to the right
- when you want to go back to the previous digit (left) press CLR
- when you finish editing, use the F button to move the edit field “off the screen” and it will be saved

recall the long distance by pressing the arrow
long press the F button until the screen flashes, then long press the F button again

Press the Light button on the housing to adjust the brightness of the tripmeter display.

press the CAL button until the P1 and P2 diodes start flashing. They will flash approx. 10 s and then you have time to change the sensor inputs
pay attention to the colors. The sensor whose LED lights up blue while blinking will remain on
while flashing, press the CAL button successively to switch inputs, which is indicated by the blue color overlapping the flashing red one.
you can choose combinations:
- P1 – flashing blue, counting from input 1
- P2 – flashing blue, counting from input 2
- P1 + P2 – both flash blue, counting from both inputs, summing the pulses.
once you have set the appropriate input, wait until the LEDs stop flashing
Your selection will be accepted

Required program: min.3.70.16 of 2025.08.15

press the MENU button and then without releasing it press the UP or DOWN arrows
the display will start flashing
Press the UP or DOWN arrow again and again. In this way you change the parameter that is displayed on the driver’s display
when you select the parameter you want, stop pressing the buttons until the screen stops flashing

press the LIGHT button and then without releasing it press the UP or DOWN arrows
L000 will light up on the display
Press the UP or DOWN arrow again and again. This is how you set the speed in km/h at which the SPEED LIMIT indication will start to work
when you have set the desired speed, stop pressing the buttons until the screen stops flashing