Calling up the configuration menu
- To bring up the configuration menu Turn on the tripmeter (see: Turning on/off the H-101 tripmeter). Skip this step if the tripmeter is on.
- Then bring the tripmeter to the H-101 Home screen (see Home screen on page H-101). Skip this step if you are already in the home screen position.
- press the MENU button for 6 seconds, until ConF is displayed on the displays.
The most important rules for navigating the menu are below:
- menu selection, parameter change – up and down arrow keys
- enter the parameter, save – OK button
- exit from the parameter, rejection – CLR button
- entering the menu, exiting the menu – long MENU button (6 seconds)
Example. Changing the settings for calculating the route on GPS
- bring to the start
- enter the menu – long MENU button (6 seconds)
- find gps d – up and down arrow buttons
- enter the parameter – OK button
- change setting – up and down arrow buttons
- confirm – OK button
- exit the parameter – CLR button
- exit the configuration menu – long MENU button (6 seconds)
H-101 tripmeter configuration menu – list of parameters
GPSd – enabling, disabling the calculation of the route from GPS. If you want the tripmeter to calculate the route only on the basis of the GPS system – NECESSARY TURN OFF THE COUNTING FROM THE SPEED SENSORS.
