Na tej stronie dowiesz się:

Definitions – explanation of terms and abbreviations

CAL – calibration button
INTERMEDIATE ZERO – deleting the short path
TOTAL ZERO – erasing the long road
VIEW – button for viewing additional parameters
Switch +/-10m – long path correction
Switch -/0/+ – change the direction of road counting: counting backwards, disabling counting, counting forwards
DIM – button to change the brightness of the display
FAST – button for accelerating the change of values : during tripmeter calibration, during path correction

Switching on/off

Classic and Classic GPS	Classic H, Classic H GPS
The tripmeter has a power switch. This is the left switch located on the bottom of the case. Slide it to the right to turn it on or to the left to turn the tripmeter off.	Once the power is turned on in the vehicle, the tripmeter is ready for operation. The tripmeter does not have a power switch. If necessary, install an additional switch on the red wire supplying the tripmeter.

Starting measurements

To start measuring, the tripmeter must have a source of information about the distance traveled connected and calibrated: sensors or GPS (if built-in). See chapters: Configuration and Calibration.

Measurements – operation

After powering on, the tripmeter will show zero short distance values in the left window and zero long distance values in the right window. Start driving. This will increase the distance values (if the -/0/+ switch is set to the right).

Deleting the short path

Press the INTERMEDIATE ZERO button to delete the short path.

Erasing the long road

Press the TOTAL ZERO button to erase the long path.

Correction of the long road

The top hebel switch located on the right side of the tripmeter is used to correct the long path. You can use it:

Tilt it up once to add 10 m or down to subtract 10 m. Repeat this action if you need
Tilt and hold the switch up to add distance or down to subtract

Full correction of the long road

Using the Long Way Correction functions and adding correction combinations with the FAST button pressed can set the desired long way value very quickly.

press the FAST button and then tilt and hold the switch up to add FULL KILOMETER distances or down to subtract FULL KILOMETER distances

Change the parameter in the left window

Press the VIEW button briefly to change the displayed parameter.

Changing the direction of charging

The lower hebel switch, located on the right side of the tripmeter, is used to change the direction or lock the count. The switch has three positions:

left marked”-“: tripmeter counts backward
middle one marked “0”: the tripmeter does not count
Right marked “+”: tripmeter counts forward

Brightness adjustment

Successive presses of the Dimmer button change the brightness of the LED displays and button backlighting. Press Dimmer briefly until you get the desired brightness.