Na tej stronie dowiesz się:

Treat the tripmeter on a par with every part of your vehicle. The tripmeter requires correct assembly and configuration. Read the manual, do a test drive during which you will learn how to use and at the same time learn the functions.
In training, do not hesitate to experiment with settings – you may find a better configuration than the one you are used to.

Starting measurements from the start screen

press RUN which will cause the short route indications TRIP/PARTIAL and ODO/TOTAL to flash – ready to start
press CLR briefly to start measurement

Deleting short distance (TRIP/PARTIAL)

press the CLR button briefly.

Long distance correction (ODO/TOTAL)

press the arrow to correct the distance.

The correction value is related to the measurement resolution settings |H-100| Configuration >> Tripmeter settings, and it will be 1m, 10m or 100m.

Entering long distance values (ODO/TOTAL) – full correction

press the OK button to call up the editing screen – one horizontal line will appear on the display next to the route indication
use the arrows to increase/decrease the digit value
use the OK button to move the edit field to the right
when you want to go back to the previous digit (left) press CLR
when you finish editing, use the OK button to move the edit field “off the screen” and it will save

A new value for the ODO/TOTAL route has been introduced. Press OK again to save.

Deleting long distance (ODO/TOTAL)

press the OK button briefly until the ODO/TOTAL value starts flashing, then press the OK button again briefly to clear the value

Adjusting the brightness of the display

Press the Light button on the housing to adjust the brightness of the tripmeter display.

Changing the sensor input during measurements

press the CAL button until the P1 and P2 diodes start flashing. They will flash approx. 10 s and then you have time to change the sensor inputs
pay attention to the colors. The sensor whose LED lights up blue while blinking will remain on
while flashing, press the CAL button successively to switch inputs, which is indicated by the blue color overlapping the flashing red one.
you can choose combinations:
- P1 – flashing blue, counting from input 1
- P2 – flashing blue, counting from input 2
- P1 + P2 – both flash blue, counting from both inputs, summing the pulses.
once you have set the appropriate input, wait until the LEDs stop flashing
Your selection will be accepted

Required program : min.3.70.16 of 2025.08.15

Change the parameter on the driver’s display, e.g. display 8

press the MENU button and then without releasing it press the UP or DOWN arrows
the display will start flashing
Press the UP or DOWN arrow again and again. In this way you change the parameter that is displayed on the driver’s display
when you select the parameter you want, stop pressing the buttons until the screen stops flashing

Setting the speed at which SPEED LIMIT is signaled

press the LIGHT button and then without releasing it press the UP or DOWN arrows
L000 will light up on the display
Press the UP or DOWN arrow again and again. This is how you set the speed in km/h at which the SPEED LIMIT indication will start to work
when you have set the desired speed, stop pressing the buttons until the screen stops flashing

Edit the speed at which SPEED LIMIT signaling will occur

do as when setting up

Clearing the speed at which SPEED LIMIT is signaled

Do as when setting, but set the speed value to 000