MENU Tripmeter iTripcomputer H-51.

Tripmeter H-51 | Specifications
Service – basics | Service during a rally
Connection | Configuration | Calibration | Operating modes | Azimuth mode operation.
Specifications | FAQ

Calling the Configuration Menu

Turning on the Device

• Power supply: Make sure the tripmeter is properly connected to the power supply. Turning the device on is the first step in the setup process.

Access to the Start Screen

• Start Menu: If you hold down the MENU button for a long time, four horizontal bars [—- ] will appear on the display, indicating that you are ready for configuration.

Enter Configuration

• Device configuration: To enter configuration mode, hold down the MENU button again for a long time. If CONF appears on the screen, it means you are in configuration mode.

Navigation in the Configuration Menu

• Navigating the Menu: Use the top and bottom arrows to navigate between menu options. Selecting a specific parameter is done by pressing the function button F

Parameters Configuration

Work Type (TYPE):

• Options:
  MASTER (primary mode), recommended
  GARMIN (compatible with Garmin devices),
  SLAVE (secondary mode).

Units of Measurement (UNIT):

• Options:
  Metric for most countries,
  Imperial for the UK and countries using the imperial system.
• Confirm the selection with the F button

Operation of Sensors (PULSES):

• ON: Select this option when using only external speed sensors or external speed sensors and GPS at the same time.
• OFF: Set to use only the GPS system.
• Confirm the selection with the F button

GPS Module(GPS):

• INDOOR: Standard GPS setting.
• NONE: Option for non-GPS modes.
• Confirm the selection with the F button

GPS Type (GPST):

• OLD: Setting for older tripmeter models.
• NEW: Setting for tripmeters manufactured in 2023.
• Confirm the selection with the F button

GPS Way (GPSD):

• ON: GPS Parameter Road in H-51 tripmeter
• OFF: Disables this feature.
• Confirm the selection with the F button

GPS Method (GPSM):

• GPS 1: Standard measurement method.
• GPS 2: An alternative method, used under specific conditions.
• Confirm the selection with the F button

Time Zone (UTC):

• Setting appropriate for your location (e.g. 1 for Poland).
• The scale subtracts the range from -12 to +12 hours
• Confirm the selection with the F button

Daylight Saving Time (DST):

• OFF: Standard time.
• ON: Daylight Saving Time.
• Confirm the selection with the F button

Zero ODO (ZERO K):

• OFF: Standard setting; ODO is not reset automatically.
• This feature is intended for advanced users.

Resolution (DSTR):

• Select measurement accuracy: 1 meter, 10 meters, 100 meters.
• We recommend choosing 10 meters, the most frequently chosen, the most optimal
• The selection is made using the arrows, and it is confirmed by pressing the F button

Parameter Program:

• Check tripmeter serial number and software version.

Saving Configuration

• Finish Configuration: To save all changes, hold down the MENU button for a long time. The device will be restarted, confirming that the configuration has been saved.

Additional Tips

• Selection Confirmation: Each selection in the configuration menu is confirmed by blinking the display three times.
• Cancel Changes: The MENU button allows you to return to the previous screen without saving changes.
• Note that unsaved changes will be lost when you exit the device (shutdown).
• Individual Parameter Change: If you want to change only one parameter, select it with the arrows, confirm with the F button, and then finish the configuration by long pressing the MENU button.